attaching A/F guage

[GTManiac]

I just installed a 3 guage pod and I have an A/F guage and a few others and the one that I can't figure out (even using the guru's guide) is the A/F guage install. So I'm asking for someone who has installed this guage to help me out and take some clear and defined shots of where this thing gets hooked up and how I route it to the guage. Thanks for any and all help and not dissing the guru for his instructions, I just suck unless it's a no brainer type of thing.

[tshboy]

it's really easy if you have the A/F pigtail that goes inline just ahead of your O2 sensor.

1. The O2 sensor is on the backside of the engine. It will be tight to get to if you have a STB.

2. Hook up the purple wire there and run it to your passenger compartment. There is a rubber grommet through the firewall. It's located behind and below the main fuse box under the hood.

3. Hook up the black and red wires coming from the gauge to a 12V ignitioned source and ground it. I tapped into my hard-wired radar detector. Use the radio accessory fuse location (10 AMP i believe). There is a chassis ground screw in the fuse box.

viola.