Door Glass Sash Out of Run Channel #01-08-64-012C (01/28/2003) [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Door Glass Sash Out of Run Channel #01-08-64-012C (01/28/2003)


iceman
03-20-2003, 08:13 AM
Door Glass Sash Out of Run Channel (Repair Door Glass Sash Channel)
1999-2003 Oldsmobile Alero

1999-2003 Pontiac Grand Am

This bulletin is being revised to add the 2003 model year and update the Parts Information. Please discard Corporate Bulletin Number 01-08-64-012B (Section 8 - Body & Accessories).

Condition
Some customers may comment that the door glass is out of the channel.

Cause
The door glass sash channel may have come off the glass or the sash channel clip may be damaged.

Correction

Caution
When working with any type of glass, use approved safety glasses and gloves to reduce the chance of personal injury.



Important
If the clip location is unknown, install the glass in the full up position and attach the new clip to the regulator and power the regulator to the full up position. This will set the clip in the proper position so you can mark its location.


Replace the sash channel following the repairs listed below.

Sash Channel Came Off Glass; Adhesive on Glass
Remove the door glass and lay it on a protected table.
Mark the location of the clip with tape.
Remove the adhesive with a one edge razor blade.
Clean the glass with Isopropyl alcohol.

Important
Install adhesive into the applicator and squeeze some adhesive out before you install the mixing tube. After the mixing tube is installed, run a test bead the length of the mixing tube to ensure a good mix.


Fill the sash channel clip with adhesive.
Install the clip in the marked location.
Reinstall the door glass and put the glass in the full up position for 24 hours.
Sash Channel Damaged
Mark the edge of the clip for location.



Cut off the bottom edge of the guide with a cut off wheel.



Using a thin flat blade putty knife and a hammer, carefully remove the plastic piece on each side of the glass. (Refer to the illustration above).



Clean any adhesive from the glass using a one-edge razor blade. .
Clean the glass with Isopropyl alcohol.

Important
Install adhesive into the applicator and squeeze some adhesive out before you install the mixing tube. After the mixing tube is installed, run a test bead the length of the mixing tube to ensure a good mix.


Fill the sash channel clip with adhesive.
Install the clip in the marked location.
Reinstall the door glass and put the glass in the full up position for 24 hours.
Parts Information
To order the applicator for the adhesive, call GM Tools at 1-800-468-6657 and press option 2. The applicator P/N is 310-300.

Part Number
Description

22689012
Sash, Side Door Window

12378568 (US)

88901676 (Canada)
Structural Urethane Installation Adhesive