2KGAGTguy
06-17-2003, 03:48 PM
OK, this one is easy. My blinkers weren't always working, and fiddling with the Hazard Switch always made them come back to life. So for CAN$50.00 I got another one and changed it.
You will need a common screwdriver, a 1/4" drive ratchet(Any bigger and you'll risk over-torquing the screws), a short extension and a 7mm socket.
1. Using the screwdriver, gently pry at the dash cover in several places over stereo and HVAC. Cover should pop away taking with it the ETS switch, Hazard Switch, Lighter socket, and Ignition Switch overlay. The overlay popped right out on me, but just snaps back in place after the dash cover is back on.
2. Remove connectors from ETS and Hazard Switch.
3. These two switches are held in place by a bracket on the back of the dash cover that has three screws. Using the 7mm socket and 1/4" ratchet, remove these three screws, and separate bracket from cover.
4. The Hazard Switch is held in place by a clip on either side. You will need to press these clips in to slide the switch out. You may need the screwdriver to help you out here.
5. Switch should slide out towards the front.
6. Installation is just the reverse of removal.
You will need a common screwdriver, a 1/4" drive ratchet(Any bigger and you'll risk over-torquing the screws), a short extension and a 7mm socket.
1. Using the screwdriver, gently pry at the dash cover in several places over stereo and HVAC. Cover should pop away taking with it the ETS switch, Hazard Switch, Lighter socket, and Ignition Switch overlay. The overlay popped right out on me, but just snaps back in place after the dash cover is back on.
2. Remove connectors from ETS and Hazard Switch.
3. These two switches are held in place by a bracket on the back of the dash cover that has three screws. Using the 7mm socket and 1/4" ratchet, remove these three screws, and separate bracket from cover.
4. The Hazard Switch is held in place by a clip on either side. You will need to press these clips in to slide the switch out. You may need the screwdriver to help you out here.
5. Switch should slide out towards the front.
6. Installation is just the reverse of removal.