View Full Version : Stupid question on changing of angel eye bulb
07-31-2004, 01:46 PM
Well my bulb burned out, and I didn't know it was an H3 bulb in there, so I have a wasted 880. Anyhow, I noticed its not the simpile turn and pull type, not sure, do I just pry it out of there in order to change it??? I know I'm stupid. Thanks
07-31-2004, 08:33 PM
Are you talking about the hella angel eye's? If so you just need to unscrew the 2 screws on the back plate. Then remove the screw inside holding down the black ground wire. The bulb should slide out from under the screw on the other side of the bulb.
H3 bulbs have a built in positive wire and can come with a connector that doesn't work with the wire harness included in the hella kit. My new nokya H3 bulbs had a spade type connector while the hella kit uses a bullet type. It's easy enough to make an adapter for it though.
vBulletin® v3.7.2, Copyright ©2000-2017, Jelsoft Enterprises Ltd.