Resurrecting GA 3400 [Archive] - Forum


View Full Version : Resurrecting GA 3400

08-16-2004, 09:42 PM
I'm in process of transplanting a 2000 GA 3400 engine into a '87 Fiero. As it turns out, the bolt spacing has grown much like the size of the engine. Does anybody out there have a set of heads pulled off. I'm tryng to determine if there is a water jacket located in the area where I want to add a new tap hole. See photo attached.

The new hole is located approx .6" from the original hole in the 5 o'clock position. Thanks to any inputs!