Electric oil pressure guage on 2.4L?

[CyberRad]

I was wondering how to install this seeing since the instructions are for the 3.4s on this board.

[Molson]

I have the mechanical oil press on my 2.4 but its basically the same thing.. I went to the parts store, got a bunch of fittings (some 90's, 45's, extensions, etc)

Take out the stock sender out of the top of the head, drivers side. (remove the cover, etc) Then I stuck in some fittings to bring it out past the fuel lines, put a "T" connector on, put the stock sending unit back in, then my lead to the gauge. Should be pretty similar to yours. Unfortunatly I don't have a pic of this, I'll see if I can score a digi cam in the near future.

[CyberRad]

Pictures of what you are talking about would be great. I need at least a pic of where the whole is.

[Molson]

its easy to find.. Take the cover off first (the thing that says 2.4 TWIN CAM) look between the cams, where the spark plugs are. on thre right side, on the forward cam housing, there is a sender screwed into a hole.

[Irate]

Thanks for the help Jim - I'm going to try to install a mechanical one... heh