Window regulator install problems [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Window regulator install problems


seacow
01-19-2005, 09:50 PM
A trip to the drive through ATM on tuesday night left me with a window dropped down into the door. I found the little white plastic guides at a local dealership and tried installing them myself. I got the regulator out and installed the guides fine. However, after reattaching the glass i rolled up the window and noticed that the back end of the glass is slanted about a half inch too low, leaving an opening. I took the whole assembly apart 3 times and cannot figure it out. Does anybody have any installation tips I can try?

dahvaio
01-23-2005, 01:25 AM
Roll up the window with the door panel off. This will allow you to see what is happening with the window.

Before you roll up the window make sure that the bottom of the window is level and then slowly roll it up and see where the one side is getting jammed.