quick break question [Archive] - GrandAmGT.com Forum
PDA

View Full Version : quick break question

hodgson316
08-10-2006, 01:25 PM
Recently I bought a set of front and rear d/s rotors from a member here. The rotors aren't looking too good. so I was wondering is it alright to use a sander on them to clean it up a bit... I'll post pics in a minute to show you what they look like. Thanks for the responses.
tenspeed
08-10-2006, 09:49 PM
Sanding or wire brush shouldn't be a problem. Don't use any WD40 or wax on the braking surface.

I painted the center part on mine.
cmtapanes
08-10-2006, 10:18 PM
If you planning to install the rotors your self you can take them to any brake shop and ask them to re-surface the rotors, that should be around $10 per rotor. You can sand the center part of the rotors. Like TENSPED say dont apply any type of oil or wax on the braking surface.
hodgson316
08-16-2006, 06:15 PM
If you planning to install the rotors your self you can take them to any brake shop and ask them to re-surface the rotors, that should be around $10 per rotor. You can sand the center part of the rotors. Like TENSPED say dont apply any type of oil or wax on the braking surface.

really? for that price i might as well just have them resurface them. Thanks again for the responses