2000 GA...Problems

[freeze12]

2000 GrandAm 3.4L

I changed the plugs on this car & now the car will not fire up.No security light etc. Car ran fine before changing plugs. The 2 wire plug that goes into the CoilPack on the passenger side looked like it had heated up & bare wires were showing.So after the first no start I repaired the plug & still the same problem.I checked & double checked all harness plugs & all were plugged in.
Hopefully someone can help that has experienced the same situation....Thanks

[LoboMan7409]

are all the wires in the right order?

[freeze12]

yes.as I took them off one at a time.

[Sprucegagt]

Are you sure you have all the wires connected to the coil pack? You should have the main plug on the passenger side and two smaller plugs on the drivers side. All are needed to start the car.

[freeze12]

Problem solved...It took a while put the power wire to the control module was burn't farther up in the harness,replace wire & the engine fired right up.Thanks to those that replied to my post!