code p0113 will not clear [Archive] - GrandAmGT.com Forum

PDA

View Full Version : code p0113 will not clear


DAVES2000GT
04-16-2007, 06:15 PM
I am getting a code P0113 I changed the air charge/temp sensor
was only $12 reset the computer overnight and the check engine came
right back on, Any ideas? is thier a way too test or bypass?
Thanks!
Dave

justinw
04-16-2007, 07:35 PM
Check the wires for damage, etc. My experience with P01113 is that it only came on when it was disconnected.

DAVES2000GT
04-16-2007, 07:41 PM
Were was the break on yours? close too the plug?

justinw
04-17-2007, 08:01 AM
No break, I had the problem when I removed the intake and forgot to put the plug back in.

DAVES2000GT
04-17-2007, 08:07 AM
Mine is connected and I bought a new sensor but it still dont work??
I am baffled....

heeroyue2002
04-17-2007, 10:43 AM
sometimes the sensors can be dead/defective even if they are new.

DAVES2000GT
04-17-2007, 03:31 PM
Have you seen a sensor bad that was brand new?
Maybee I will try that and take it back,
Thanks!
Dave

DAVES2000GT
04-17-2007, 07:31 PM
replaced the sensor again and replaced a couple vacum lines and 5 mintues
of driving latter it turned off and cleared the check engine!
it was one of those things...
Now too get my inner headlight adjuster and new/used clips

DAVES2000GT
04-19-2007, 09:28 AM
Well it just came back on, I give up!!
this thing has got me stummped, it runs
so much better when the light is off too!!!

any suggestions, I dont wanna keep going back too autozone too
have them check my codes

Dave


Ps...still looking for headlight hardware, adjusters and clips

heeroyue2002
04-19-2007, 11:06 AM
my o2 sensors were defective when i first installed em, had to exchange em.

lvemy3100
04-19-2007, 11:27 AM
as stated previously.... check the wiring....