1/4 13.6

[Gold99HO]

yea soooo close to 13.5 it wasnt even funny.. i think once i do rockers i should be down to 13.1-13.4

right now all i have done is 3.4 pulley, 3in down pipe , open cone, DHP... and .500 of knock

[Ajaxus]

slip? :)

[lone_wolf025]

For a minute there I thought it was for the Grand Am. But I second AJ's request for slips. Its always fun to see how things played out from a full slip.

[Ajaxus]

it would be nice if a grand am could do that with so few mods..*sigh*

[Gold99HO]

ill take a pic....

[drumking1721]

it would be nice if a grand am could do that with so few mods..*sigh*

haha yea......lets jst do whats in the pic i attached!

[ryanbgb22]

i've seen that car on a site somewhere before. That'd be awsome...

[GrandAmGT1996]

haha yea......lets jst do whats in the pic i attached!

From what I've heard, that guy spent a lot of money and had a lot of computer headaches with that car. He ended up selling it IIRC

[drumking1721]

yea well....if you got the money then go for it

[Ajaxus]

he ran the gp and ga pcm's back to back to pull it off...and there's tons of info on the project here if you search...now, let's get this thread back ontopic, shall we? :)

[drumking1721]

hey now....i was stayin on topic,he said something along the lines and i threw in a pic.This thread is about a gtp and i put in a pic of a gtp engine

[XtremeGaGt00]

i would def not mind doin that kinda awap, too bad i dont have access to welders at my cost and metal and all that...would def be fun....

[DomesticFreak]

I've wanted to swap that engine into my J and then I wanted to swap it into my GAGT, but from what Ajaxis has said it won't be happening any time soon, so damn, I wish.

Maybe I'll just go find myself a 01, 02 GTP and tub it to get all that damn weight out...

Also, awseome for getting to the 13's. I read the title and thought a GA had done it as well.