Drivers windshield pillar [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Drivers windshield pillar


nate2023
08-15-2007, 10:28 PM
Question,
How do i remove the drivers windsheild pillar (the one everyone replaces with the gauge pods) without breaking the plastic rods.

KhellendrosxS
08-15-2007, 10:31 PM
All you have to do is pull. It comes off kinda hard but just work at it a bit and it will pop right off.

nate2023
08-15-2007, 10:33 PM
i pulled strait but the pillar has a hole in it where JUST the plastic rod broke of. i want to go to the junkyard and get one, but if i break it, uhoh

Bryan
08-15-2007, 10:34 PM
Just make sure you pull the same direction as the clips. If you pull on an angle you're setting yourself up to break them (like I did).

hass
08-20-2008, 01:21 PM
Ugh, I was hoping there's a technique for this. lol.
When I bought my GA both sides were broken, so I double stick taped them on there, then eventually it fell off... like 2 months later.

So I havent had any on for the last two years... went to a junkyard and broke all the clips on the ones I tried to take off. lol :\
/sigh.

Must have been pulling on an angle or something I guess.