Not LIM, but other torque specs? Help! [Archive] - Forum


View Full Version : Not LIM, but other torque specs? Help!

12-15-2007, 10:12 PM
I am having this guy help me put a whole new motor in my car. I went from having a 2000, 3400 to a 2004, 3400. He said he needed torque specs, but I don't know what kind. What torque specs would I need to install and a 3400 sfi, and what are they?

12-15-2007, 10:36 PM
a little more specific info on what parts he has questions about.

the only ones would be motor mounts , flywheel, and trans to engine.

Install the bolts that attach the converter to the flywheel.
Tighten all of the bolts to 62 Nm (46 ft. lbs.) . Re-torque the first bolt after all three have been tightened.
Install the converter cover bolts.
Tighten the converter cover bolts to 13 Nm (115 inch lbs.)

Install the engine mount assembly. Notice: Refer to Fastener Notice in Service Precautions.
Install the body fasteners to the engine mount.
Tighten the bolt to 130 Nm (96 ft. lbs.) .
Tighten the nut to 66 Nm (49 ft. lbs.) .

if you need anymore i can pull them off of the alldata i have

12-15-2007, 10:48 PM
I hope that is all he needs. I can't be sure right now, but I will print this up and have him take a look at it. Is there anyway I can get the specs online, if not how could I get all the specs?

12-15-2007, 11:14 PM
something like a haynes manual might have them all. i got shop manuals for the grand am so its got all that covered.

ill see if i can get the whole page saved so you can print it out.

theres not really much if the engine is all together , you just got the mounts and where the engine bolts to the tranny and flex plate to torque converter bolts.