Hazzard switch/4-way flasher not working; but the turn signals still do? [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Hazzard switch/4-way flasher not working; but the turn signals still do?


Mike Jung
07-05-2008, 01:43 AM
For those in the future:

If anyone has their hazard switch/4-way flasher stop working.
But have their turn signals still working.

Check their driver's side fuse box for a blown fuse.
& check all their turn signals for a blown bulb.

I happen to have a blown rear turn signal bulb.
Which caused a fuse to blow on my hazard switch circuit.

But the turn signals still worked.

Who would of thought: A blown turn signal bulb, would blow the hazard switch circuit fuse; but leave the turn signals still functioning ?

killswitch08
07-06-2008, 08:33 AM
i have the same problem. my hazard button doesnt work but the signals work fine. Ever since i put in my deck and put the main panel back on they havent worked. so im guessing loose wiring or a blown fuse like you say.

Mike Jung
07-06-2008, 03:15 PM
i have the same problem. my hazard button doesnt work but the signals work fine. Ever since i put in my deck and put the main panel back on they havent worked. so im guessing loose wiring or a blown fuse like you say.
Does the ETS switch (left on the hazzard switch button) work ?

If it does not:
Sounds like you need to take the front cover off again.
& check to see if the buttons are making contact with the switches behind them.
(Had it happen to me: when getting a Clifford alarm system installed.)

Gizm0815
07-06-2008, 03:36 PM
mike did the relay go bad? i dont remember if they are separate

Mike Jung
07-06-2008, 03:38 PM
mike did the relay go bad? i dont remember if they are separate
No, the relay was ok.

killswitch08
07-06-2008, 04:54 PM
ets button works fine. the fuse for the hazard lights is under the hood or is it the side panel fuse box ?