3500 swap problem, crankshaft sensor [Archive] - GrandAmGT.com Forum

PDA

View Full Version : 3500 swap problem, crankshaft sensor


realestdriver
04-25-2009, 08:18 PM
I was swapping over all my sensors and stuff when I was taking off the crankshaft position sensor on the rear of the engine and the one from the 3400 is too long to fit. I can rewire the 3500 sensor, but its a three wire and the 3400 sensor is a two. What you guys suggest.

p.s.....I have my external crank trigger, this only covers for the side pulley right.

westerndragon
04-25-2009, 08:22 PM
check a haynes one is probably a ground