Front bar bushings [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Front bar bushings


FunkZ
11-20-2009, 09:38 PM
I want to replace the front sway bar bushings and endlinks. What is the size bushing I need for the stock bar? 24mm? 22mm?

lastryghts
11-21-2009, 06:59 AM
Stock sway bar or speedbuilt from PFYC?

mfuller
11-21-2009, 07:44 AM
Stock swaybar is 24mm in diameter, so you need 24mm midpoint bushings.
Endlinks are a bit universal, but when you gt replacements, you may need to trim the spacer. The way to set them up right is so the the swaybar is parallel to the lower control arm while the car is on level ground.

FunkZ
11-21-2009, 01:26 PM
It's the stock bar, just wasn't sure of the size. The parts stores showed a couple.

I looked on PFYC but all I saw was the speedbuilt replacement bushings... they still sell a bar?

mfuller
11-21-2009, 06:11 PM
I looked on PFYC but all I saw was the speedbuilt replacement bushings... they still sell a bar?

I highly doubt they have any bars left. Too bad, since I really enjoy them. Too small an audience though.

FunkZ
10-19-2010, 10:45 AM
Am finally getting around to ordering this, Moog part # K6679 for stock 24mm front bar. Figured I might as well do the rear while I'm at it, anyone know the stock size of that on the GT?

*edit* Okay, found this thread (http://www.grandamgt.com/forum/showthread.php?t=79195) that indicates the rear size is 15.3mm - seems an odd size. Does that translate to any specific Moog part # or do I have to go to the dealer?

WidbyJ
10-19-2010, 05:06 PM
I'd go to Autozone and use Energy Suspension generic Poly bushings, with grease fittings if they have them. Just measure in inches cause....