Changing CV Axles and seals [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Changing CV Axles and seals


99GT
03-05-2012, 04:25 PM
Hey guys, I'm going to be changing my cv axles, replacing the leaky seals for the shafts and replacing outer tie rods.

It's been a while since I removed the drive axles, and I cannot find any books that are in detail on this subject, but last time I did it I didn't have to remove the calipers. I do not plan on removing them.

Does anyone know of any sites that have very good and detailed instructions on the removal and replacement of the seals? I haven't replaced the seals before and I want to do it all perfectly. I have also read something about doing a certain drive axle first and removing some sort of clip, which I didn't do last time.

O1GAGT
03-05-2012, 04:34 PM
Not a grand am, but it should give you a good idea of what needs to be done.
http://www.youtube.com/watch?v=6xb7xil4PAw