Outer Windsheild molding [Archive] - GrandAmGT.com Forum

PDA

View Full Version : Outer Windsheild molding


zukiracer19
04-08-2013, 08:35 PM
Where can I get the molding for the outside of the windshield on the right passenger side.. ? I tried gluing it back in but keeps popping up when i'm driving and sticking out.

kzulfic
04-08-2013, 08:45 PM
Where can I get the molding for the outside of the windshield on the right passenger side.. ? I tried gluing it back in but keeps popping up when i'm driving and sticking out.

Go to the j/y, find GA, peal weather stripping back, remove 3 screws holding trim in, voila, you have your part.

zukiracer19
04-08-2013, 08:50 PM
Where would the screws be? looks like it just snaps in

TDavis
04-08-2013, 09:01 PM
I remember when I got my windshield replaced on my '99 Cavalier they replaced the molding as well and it looked so much better since the old molding was faded.

Have no idea about the GA molding though. Just thought I'd share a story.

kzulfic
04-08-2013, 09:02 PM
Where would the screws be? looks like it just snaps in

Let me see if I can get a pic.

kzulfic
04-08-2013, 09:06 PM
Go to your car, open your door, pull back the weather stripping and you'll see them.

Too dark to get a pic atm.

Jimmayy12
04-09-2013, 05:47 AM
Open the door. Pull weather stripping back, you will see 3 small screws each about a foot away from each other. Take the 3 screws out and the molding should pretty much just fall off! A short screwdriver would work best for this as the bottom screw is in a tight spot. You can pick them up at a Wreckers. I got mine for $15/ side.