When changing the hub assembly.... [Archive] - GrandAmGT.com Forum

PDA

View Full Version : When changing the hub assembly....


DucksInARow
09-02-2013, 04:31 PM
I've never changed the hub/bearing assemblies before. I've got the usual SVS/ABS light combo, and the problem is resulting from the driver-side front speed sensor. I was reading the sticky about this process. Looks fairly straight forward.

But I haven't seen anything about the need for greasing the bearings. As far as I can tell, the bearings on the new unit are completely sealed, and there's no need to apply any grease. Can anyone confirm this for me? I just want to be completely sure before I proceed.

Thanks.

The_Maniac
09-02-2013, 04:44 PM
You are correct, the bearings are in a sealed unit. Nothing to grease. I do tend to apply some "anti-seize" on the mating surfaces of the steering knuckle and the hub assembly in hopes to make removal easier if I have to do this again in the future.