Forum Forum (
-   HOW TO's (
-   -   Heater Blower Replacment (

joey p 12-18-2010 09:32 AM

Heater Blower Replacment
Just got done with this. You will need a 5.5 Metric Socket or a 7/32 Socket and a 1/4 inch Socket to do this job. First remove the Glove Box by removing the four screws that hold it in. Than remove the panels under the glove box about three screws. Now you can access the blower motor. You will see three screws holding the motor in place. Remove the three screws that are 5.5 metric or 7/32 and drop the motor down than remove the connector and its out. Reverse the process to reininstal......Total time it took was about 40 min to do this.:applause:

All times are GMT -6. The time now is 11:58 PM.

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2011