View Single Post
Old 12-18-2010, 09:32 AM   #1
joey p
GAGT - Newbie
 
AKA: joey
Join Date: Jul 2008
Location: plainfield,il
Posts: 16
Vehicle: 2002 gt
joey p Gettin' there
Heater Blower Replacment

Just got done with this. You will need a 5.5 Metric Socket or a 7/32 Socket and a 1/4 inch Socket to do this job. First remove the Glove Box by removing the four screws that hold it in. Than remove the panels under the glove box about three screws. Now you can access the blower motor. You will see three screws holding the motor in place. Remove the three screws that are 5.5 metric or 7/32 and drop the motor down than remove the connector and its out. Reverse the process to reininstal......Total time it took was about 40 min to do this.
joey p is offline   Reply With Quote