View Single Post
Old 04-17-2017, 01:09 PM   #3
00redse
GAGT - Newbie
 
AKA: Mike
Join Date: Mar 2017
Location: PHX AZ
Posts: 19
Vehicle: 2001 GA SE
00redse Gettin' there
Thanks.

So it's good for low boost only, PCM isn't reading boost.

Nice move gm. (At least the 2.4 s/c kit let the pcm read boost)

So, from my understanding, removing the MAF forces the car to run in Speed Density mode, right?
And it also makes the tranny shift super hard and at full line pressure which is bad.

What else happens when you delete the MAF?

Seems like if it's just the trans issue, then a 5 speed swapped car could just run w/o MAF and fake a 2 Bar MAP sensor with HPTuners. But this seems too simple (not that the 5 speed swap is "simple"), so what am I missing, or not taking into account?
00redse is offline   Reply With Quote