GrandAmGT.com Forum
http://www.pfyc.com GrandAmGT.com Premium Memership Signup
RotorsOnline.com   

Go Back   GrandAmGT.com Forum > GAGT - Main - Sponsored by www.PFYC.com > Requests and Feedback

Reply
 
Thread Tools Display Modes
Old 08-09-2005, 03:15 AM   #1
aumax
Grand-am GT freak
 
aumax's Avatar
 
Join Date: Aug 2005
Location: Québec,Canada
Age: 45
Posts: 25
Vehicle: 2002 Grand-am gt coupe
aumax Gettin' there
Daytime running light

Can someone (canadian gagt owner) tell me if it is possible to shut off those datime running light for good wihtout a light go on in the instruments panel.
Thank you to you all.
aumax
aumax is offline   Reply With Quote
Old 08-09-2005, 04:00 AM   #2
Mike Jung
400 hp & 410 lb-ft
 
Mike Jung's Avatar
 
AKA: Mike
Join Date: Aug 2002
Location: Toronto, Ontario, Canada
Posts: 4,670
Vehicle: '14 Camaro SS RS coupe
Mike Jung a trusted member
Quote:
Originally Posted by SC/TGrandAm
...
01-02 model Grand Am

No drl
1.) I should not have to say this but first disconnect the negative terminal of the battery. (cheap insurance).

2.) Remove the middle connector as stated before in the previous posts. Now locate the brown wire (pin 8 on the bottom). This is the pin that tells the BCM that the lights switch in not in the auto setting. Cut this wire, leaving enough room to extend it to the relay.

3.)The relay: Get a standard 4 or 5 pin 12V relay. Here is how the pins need to be wired. Pin 30-->go to the brown wire that you cut (on the BCM side), Pin 87-->12V (constant), Pin 86--> ground, Pin 85-->12V (switched when key is on), Pin 87a-->no connect.
NOTE: the 12V constant to Pin 87 could also be switched I do not think that it matters.

4.)Once the relay is connected I used some double sided tape and stuck it next to the fuse box out of the way. Now you need to cut the dark blue wire and ground it just like the 99-00.

5.)reconnect your BCM and your battery and test the system. Every thing worked fine for me no SVS and no DRLs.

**Apparently this method works as well**
Ground the dark blue wire(b4) and run a jumper wire from the brown wire (pin 8 on the bottom) to the sunroof fuse on the Passenger side fuse panel.

ALC bypass
1.) Remove the ambient light sensor under the dash defrost grill.

2.) Put a 10ohm resistor in place of ambient light sensor.
...
See thread: HOW TO: Override DRLs on a GA

[Do so at your own risk.]


PS: Please post in the proper sections of the forum.

Last edited by Mike Jung; 08-09-2005 at 04:04 AM.
Mike Jung is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 06:24 AM.


Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2011 GrandAmGT.com
RotorsOnline.com